Hooking up the Monoblock Amp.
#1 This is a standard mono-block power amp, one amp each is used for the left and right channel. Connect your cable from the left channel of your output device (a volume controlled pre-amp or the Desktop/Micro Amp), into the input of your power amp that controls the left speaker. Repeat this for the right channel.
#2 Then connect the each speaker to its respective power amp using speaker cable; be sure to connect the positive (red) terminal post to the positive (usually red) connector on the speaker. Ensure the power switch is off on both amps, and connect the power cables to the amps.
#3 Turn the front panel ‘output’ switches to ‘disable’. Turn on all other audio electronics in the system prior to turning on the amps.
#4 Turn the volume down on the gear feeding the power amps. Turn on Desktop Power Amps rear panel power switch.
#5 Flip front panel ‘output’ switches to ‘enable’. Slowly turn up volume of pre-amp feeding the power amps. Sweet music floats in the air!
For a full size version of this pic click Here.
